Thread Number: 28788
Zanussi FLA1002W videos |
[Down to Last] |
Post# 439190   6/2/2010 at 17:24 (5,074 days old) by servisslimline (England, Brighton & Hove)   |   | |
Checkrate/Likes
 
     
at last i have videos of my zanussi in action which has now replaced the hotpoint after the dial broke as you all know, anyway, the videos are of a darks load on 40c, non colourfast cotton 40c programme d, sorry that its darks but i felt i needed to do some vids of the machine as it has been running for roughly a month now, here is the link to my youtube channel where you will find the videos.
phil CLICK HERE TO GO TO servisslimline's LINK |
|
Post# 441818 , Reply# 3   6/15/2010 at 11:40 (5,062 days old) by servisslimline (England, Brighton & Hove)   |   | |
Checkrate/Likes
 
     
well...the good to start with, the actual wash takes up roughly 3/4 of the full cycle but, the rinses are brilliant, clear water by second rinse, always does a spin after the wash on cottons and the final spin is so much better then the hotpoint because where the hotpoint did a distribute for about 1 minute then does a 15 second 500rpm spin and distributes again for a further minute then does the second 15 second 500rpm spin and drops to distribute speed and almost instantly picks up to 1000rpm for about 3 and a halfish or so mins, the zanussi does one tumble to the right then one to the left where its goes up to a 300ish rpm spin burst, then repeats that again and does 3 tumbles and a 450 rpm spin burst, drops down to distribute speed like the hotpoint but stays for 20 seconds or something then picks p to 300rpm and slowly accelerates to 450rpm then picks very quickly up to 650rpm then again to 1000rpm where it stays for 5 mins, then does 8 anti tangle tumbles. ok so now the bad, the rinses on cottons are strange because it fills to a high water level with no agitation and does not top up after unless it goes below the low water level mark, but on synthetics and wools the rinses are how i like them, fills to low water level and starts agitation until water has reached the high rinse level mark. and the fact the motor has the whine coming from it i cant decide weather i find it better or worse than the hotpoint.
phil |