Thread Number: 40084
Gas or Electric Halo-of-heat
[Down to Last]

automaticwasher.org's exclusive eBay Watch:
scroll >>> for more items
Post# 593306   5/1/2012 at 06:18 (2,050 days old) by WaterWitch (Pomona, Calif.)        

waterwitch's profile picture
Recently my room mate purchased a set of Maytags. He got a great deal on the pair. Only $40.00! The dryer is electric. I have only been around gas dryers growing up, the same goes for him, and all my other room mates. Which do you guys and gals prefer? Gas or electric, and why?




Post# 593307 , Reply# 1   5/1/2012 at 06:25 (2,050 days old) by Easyspindry (Winston-Salem, NC)        
they both do the job.

Personally, I've only had gas dryers. Years ago, gas was much more efficient to run but not so much so anymore.

My mother had an electric HOH dryer, and it was great.

Given a choice, I guess I'd stick with gas if it's available.

Jerry Gay


Post# 593308 , Reply# 2   5/1/2012 at 06:39 (2,050 days old) by CleanteamofNY ((Monroe, New York)        

cleanteamofny's profile picture

I use both and for some reason the electric is slightly quicker than gas.
But when it comes down to preference, it would be gas all the way because the heating put moisture into the clothes while electric completely removes it!


Post# 593311 , Reply# 3   5/1/2012 at 06:53 (2,050 days old) by akronman (Akron/Cleveland Ohio)        
either/or

akronman's profile picture

I was raised with gas dryers only, and was always a fan of gas. Here in Ohio it's cheaper than electric. But this hobby has introduced me to some great electric dryers, fast, accurate controls, etc. So I somewhat favor electric now, but the price still makes me use my gas ones more.


Post# 593336 , Reply# 4   5/1/2012 at 09:24 (2,050 days old) by joefuss1984 (Little Rock, AR)        
Electric

joefuss1984's profile picture

I was raised with gas dryers but quickly came to love electric.  To me, the electric is easier to hook up, cheaper to repair should one arise and dries much quicker.


Post# 593345 , Reply# 5   5/1/2012 at 09:59 (2,050 days old) by pierreandreply4 (St-Bruno de montarville (province of quebec) canada)        

pierreandreply4's profile picture
me i was raise using electric dryers as an electric dryer drys clothes more quickly.

Post# 593358 , Reply# 6   5/1/2012 at 10:37 (2,050 days old) by Kenmore71 (Minneapolis, MN)        

kenmore71's profile picture
Generally speaking, I prefer gas dryers over electric dryers. That said, when it comes to the Halo-of-Heat design, I prefer the electric version. I currently own (and occasionally use) both a DE806 and a DG806. I did a near total restoration on the DG806 about a year ago and have done rudimentary service on the electric one.

Here are some observations:

The entire concept of the HOH dryer seems to have been designed with the electric version in mind. The gas version is a very odd setup that really looks to be almost an afterthought by the engineers. Electric HOH dryers actually dry pretty quickly given the rather paltry 4500 watt element that is in them (compared to the 5200 to 6000 watt element in other electric dryers of that era.)

The two drawbacks to the HOH electric design in my experience is that the front of the drum gets VERY hot during operation. If you overload the dryer, there is a danger of scorching if items stay pressed up against the inlet area for an extended period of time. Secondly, you need to be pretty diligent about keeping the front drum felt seal in good condition. Thousands of HOH elements have been prematurely shorted out by a stray coin, paper clip or safety pin that worked its way down into the element area and then there is a tripped breaker and a service call. Also, as the felt seal disintigrates it can break off and fall onto the heating element creating a definite fire hazard. I would never leave a HOH dryer unattended while it is drying.

Now the gas version is sort of crazy complex compared to the electric version. In the gas version, the burner is crammed in perpendicular to the drum at the very front of the cabinet. The flame cone sits directly under the front of the drum just inches away from a 3" wide felt seal that circles the entire drum. Because of this situation, Maytag throttled the burner output back to only 18,000 BTUs (compared to the 22,000 to 25,000 BTUs of comparable dryers of the period). Also, the gas version of this dryer used a standing pilot light. Not only does this waste energy, but the by-products of the pilot light burning for years makes a heck of a mess out of the mechanical and electrical "guts" of the dryer. After the restoration, I only light the pilot light in mine minutes before I want to dry. I then turn the gas off immediately after I'm finished.

In my personal experience the gas version of this particular design is slower than the electric. A normal load of towels takes about 50 minutes in the electric HOH. The same load in the gas HOH takes 60-65 minutes.

I'll post some pics of the curious design of the gas HOH dryer.

Here is the front of the dryer with the cabinet removed. See how the burner and cone sit under the front of the drum.


Post# 593360 , Reply# 7   5/1/2012 at 10:41 (2,050 days old) by Kenmore71 (Minneapolis, MN)        

kenmore71's profile picture
Here is the inside of the cabinet looking at it from the back. Note the wide felt seal that the entire front of the drum is "seated" in. The burner cone seats in the galvanized plenum at the far lower right corner. The heated air is then drawn up into the drum.

Post# 593362 , Reply# 8   5/1/2012 at 10:42 (2,050 days old) by Kenmore71 (Minneapolis, MN)        

kenmore71's profile picture
What the felt looked like in one spot after 45 years.

Post# 593367 , Reply# 9   5/1/2012 at 11:26 (2,050 days old) by RevvinKevin (Between Mickey Mouse & the Queen Mary (So. Cal.)        

revvinkevin's profile picture

 

 

I prefer gas because it's less expensive (here anyway) and seems to dry noticeably faster then electric.   Though I'm not comparing apples to apples here, one brand of electric dryer, a different brand of gas dryer.   They probably have different heat outputs and airflow numbers.

  

Kevin


Post# 593505 , Reply# 10   5/1/2012 at 20:06 (2,049 days old) by combo52 (Beltsville,Md)        
Gas Vs Elecrtic Dryers

combo52's profile picture

Basically there are few important differences in the way these two different heat sources complete the job of drying clothing, in fact most of our customers don't know weather they have a gas or an electric dryer. This is not the case with gas or electric ranges where their are major differences and advantages when comparing these two appliances. That said I would always chose a gas dryer over an electric model if your home has natural gas service for the following reasons.

 

Gas dryers are always better for the environment as their use causes only one third of the amount of carbon dioxide to be released into the atmosphere. And the air pollution produced by burning coal oil etc is much worst in general.

 

Gas dryers are almost faster at drying clothing, the only documented case where I ever saw an electric dryer was faster was when CRs tested MT HOH dryers many years ago and actually found that the gas HOH dryer took one minute longer to dry the same load. The HOH dryers in general suffered from air-flow problems as the blower drive belt had a very light tension and the lint filter was too small so they did not maintain good airflow especially if the vent system was anything but short. The 18,000 BTUs of the HOH dryers was  not the problem when it came to slow drying, many other gas dryers used 18,000 BTU burners including MTs first gas dryer designs. The gas HOH dryer because of the burners placement had to have a very sensitive hi-limit safety thermostat and as a result the burner often did not stay on enough of the time especially as the machine and it seals etc aged. The electric HOH also suffered slow drying because they had to use a 170 degree safety thermostat compared to WPs 390 degree thermostat.

 

But the best reason to always chose a gas dryer over an electric dryer is that they are FREE to own over the long run. In most cases a gas dryer will pay for itself over a 3-10 year period of time and over a life time of use you will be thousands of dollars richer. Just think if there was an option on your next car that will make owning and operating it free over your life time, wouldn't you buy it ?.


Post# 593597 , Reply# 11   5/2/2012 at 08:13 (2,049 days old) by DaveAmKrayoGuy (Oak Park, MI)        
It's GAS for Best Value & What I See Mostly Used!

daveamkrayoguy's profile picture
Gas is cheaper & more plentiful & constant, especially in commercial & industrial use!

So, naturally, I see gas, at least in the way of dryers used in nearly every household, whereas there are countless uses of it in commercial & institutional laundries, as well as in restraunts, whether it's a pizza oven, deep fryer, food warmer (a coney island I ordered my chili dog at had an un-guarded open-flame right under a table I saw while I waited for my order) or steamer!


-- Dave


Post# 968952 , Reply# 12   11/19/2017 at 17:27 by Maytag85 (25 miles from Idywild, 25 miles from Temecula. )        

maytag85's profile picture
I know the gas Maytag halo of heat dryers used a standing pilot, but where is the pilot located?

Post# 969041 , Reply# 13   11/20/2017 at 04:40 by askolover (South of Nash Vegas, TN)        

askolover's profile picture

probably just inside the heat tube because the burner resides in that vicinity and the pilot would have to be by the burner or at least in close proximity thereto.


Post# 969167 , Reply# 14   11/20/2017 at 22:45 by Maytag85 (25 miles from Idywild, 25 miles from Temecula. )        

maytag85's profile picture
The standing pilot is most likely located near the burner. I know the electric halo of heat dryers are better, but if I find a gas version I may get it since the gas halo of heat dryers aren't that common.

Post# 969176 , Reply# 15   11/20/2017 at 23:57 by DaveAMKrayoGuy (Oak Park, MI)        

daveamkrayoguy's profile picture
I still think gas is more widely used where I live--people/families with electric ranges would even have gas dryers (a friend's mother opened the WARD SIGNATURE pilot door to let me see the flame), and the rest of the appliances with the exception of a no-name electric cook top and Frigidaire French door wall oven were what made these folks Norge-Nuts! Though it was only a couple refrigerators, and a plumbed-in portable dishwasher that sat in a nook under a small "L" counter...

However, some electric range homes (including my maternal-grandparents and mine) had an electric dryer for the matter of convenience, as would at least one home with a gas range out of many, maybe to get out of the dryer having a standing pilot light that needed to be lit, or just a matter of its treatment or performance drying the clothes...

Electric dryers might make sense in apartment and logic laundries, as that's where they tend to be widely used, even as expensive all that DC power, efficiency-wise can be...



-- Dave


Post# 969268 , Reply# 16   11/21/2017 at 15:20 by goatfarmer (South Bend, home of Champions)        

goatfarmer's profile picture

The standing pilot is most likely located near the burner. I know the electric halo of heat dryers are better, but if I find a gas version I may get it since the gas halo of heat dryers aren't that common.  

You answered your own question. Around here, I see as many gas dryers, as electric.


Post# 969388 , Reply# 17   11/22/2017 at 12:15 by wft2800 (Leatherhead, Surrey)        

I know nothing much about Maytag, but I would never use a gas dryer. Electric dryers are easier to hook-up, they're considerably safer, don't require constant maintenance to avoid fires (although one does of course take care of the lint filter), don't fill your home with carbon monoxide fumes (or leak un-ignited gas)...




Forum Index:       Other Forums:                      



Comes to the Rescue!

The Discuss-o-Mat has stopped, buzzer is sounding!!!
If you would like to reply to this thread please log-in...

Discuss-O-MAT Log-In



New Members
Click Here To Sign Up.



                     


automaticwasher.org home
Discuss-o-Mat Forums
Vintage Brochures, Service and Owners Manuals
Fun Vintage Washer Ephemera
See It Wash!
Video Downloads
Audio Downloads
Picture of the Day
Patent of the Day
Photos of our Collections
The Old Aberdeen Farm
Vintage Service Manuals
Vintage washer/dryer/dishwasher to sell?
Technical/service questions?
Looking for Parts?
Website related questions?
Digital Millennium Copyright Act Policy
Our Privacy Policy