|
Thread Number: 20784
What's the secret ???? |
[Down to Last] |  |
| Post# 329676 2/10/2009 at 19:37 (5,550 days old) by toploader55 (Massachusetts Sand Bar, Cape Cod) | ||
I just can't understand why it is so hard (for me anyway) to get the lower panel of a KitchenAid Dishwasher back on ? I just can't to get them back on unless I spend 2 hours trying. I know it's suppose to angle on to the groove under the rubber gasket, but on mostly all of mine they're a bitch. What's the trick ??? | ||
|
| Post# 329685 , Reply# 2 2/10/2009 at 20:43 (5,550 days old) by magic clean () | ||
|
Ed & Steve; make sure the tabs at the lower corners, where the panel mounting screws are affixed; are bent slightly downward, this helps apply force upward to keep the vertical side flanges securely beneath the evaporation channel. Leslie | ||
| Post# 329724 , Reply# 4 2/11/2009 at 04:23 (5,550 days old) by toploader55 (Massachusetts Sand Bar, Cape Cod) | ||
|
Thanks | ||
| Forum Index: |
| Other Forums: |
|
|
|
|
|
Comes to the Rescue!
