Thread Number: 37800
Help needed filterflo shaft seal replacement....I need a new one also... |
[Down to Last] |
Post# 562151   12/9/2011 at 13:54 (4,493 days old) by kenmoreguy89 (Valenza Piemonte, Italy- Soon to be US immigrant.)   |   | |
Checkrate/Likes
 
     
Hi to all, this is the story following my receny thread about water in the tranny and weird noise.... I removed the agitator and checked the shaft and seal to understand something, and surprise surprise, I found all the shaft, the spline and inside of agitator covered by a patina of dark grease/oil.....
Looking on a site I found out the part number for the seal but I can also see that there is a support for the spline,would be maybe went bad that too, or what else? For me there's always the same problem to find parts over here in Italy, so if anyone have an extra one of these would be very appreciated if you can sell and ship one to me (I can pay everything with paypal). I just have to figure out how to remove the old seal...just pulling it? What should I do? Any help would be deeply appreciated also. I attach a link of a website that show a list of parts numbers for older GE that is very helpful , if anyone would need as well! Thank you in advance! CLICK HERE TO GO TO kenmoreguy89's LINK |
|
Post# 562152 , Reply# 1   12/9/2011 at 13:58 (4,493 days old) by kenmoreguy89 (Valenza Piemonte, Italy- Soon to be US immigrant.)   |   | |
Checkrate/Likes
 
     
|
Post# 562631 , Reply# 2   12/11/2011 at 13:07 (4,491 days old) by kenmoreguy89 (Valenza Piemonte, Italy- Soon to be US immigrant.)   |   | |
Checkrate/Likes
 
     
|