Thread Number: 38811
KA parts... help Steve in FL?? |
[Down to Last] |
Post# 575880   2/14/2012 at 11:44 (4,426 days old) by firedome (Binghamton NY & Lake Champlain VT)   |   | |
Checkrate/Likes
 
     
OK my KA parts dealer here says the gasket/O-ring/connector parts for my KDD-67 Fill Unit (coupler to the faucet) are all NLA ... the relevant parts #s: B110553 (washer kit), B110552 (aerator & connector ass'y - includes the previous washer kit),
M89038 (Gasket-seal, U-section) and/or A106955-2 (coupler, drain hose and ferrule sub ass'y, includes previous part gasket-seal). It leaks profusely at the faucet connection so will need some or all of these parts - but where can I get them? These parts, being from a portable were not common to Hobart commercial machines I'd assume. The machine is running superba except for this faucet leak! |
|
Post# 576091 , Reply# 1   2/15/2012 at 13:09 (4,425 days old) by rp2813 (Sannazay)   |   | |
Checkrate/Likes
 
     
|
Post# 576327 , Reply# 3   2/16/2012 at 12:39 (4,424 days old) by firedome (Binghamton NY & Lake Champlain VT)   |   | |
Checkrate/Likes
 
     
|
Post# 576328 , Reply# 4   2/16/2012 at 12:41 (4,424 days old) by firedome (Binghamton NY & Lake Champlain VT)   |   | |
Checkrate/Likes
 
     
from Phil Flaugher Electric in Ohio but it's very expensive ~$80, and I think all that is wrong is a bad gasket or seal, in the connector on the dishwasher, not the coupler on the faucet itself, so I hope to find just that little part and avoid replacing the whole connector assembly w/ hose... Thanks for your suggestions folks! Will see what pans out.
|