Thread Number: 78115  /  Tag: Modern Automatic Washers
Proud of myself--repaired my agitator dogs
[Down to Last]

Cool Washer Stuff on Amazon:
scroll >>> for more items
Post# 1021295   1/15/2019 at 19:50 by jamiel (Detroit, Michigan)        

After recently overloading my KM, I stripped the agitator dogs, so for $5 I've got a new set, and they went in...easily...kind of proud of myself! Was also able to clean out some ahem residue from the inside of the agitator to boot (probably should lift the top and see how bad the outer tub is...).

Post# 1021297 , Reply# 1   1/15/2019 at 20:02 by Stricklybojack (San Diego, CA)        

stricklybojack's profile picture
.
Itís an easy job, especially after you have do it once before. I plan to replace the dogs on three machines I currently have and plan to sell, unless they look fresh I will swap them out. Dog packs are cheap, especially by the 1/2 dozen or more.

By all means lift the lid, easy and satisfying to exercise the accumulated crude.


Post# 1021303 , Reply# 2   1/15/2019 at 20:51 by jamiel (Detroit, Michigan)        

Do you do it like on a BD with a putty knife an inch from the edge?

Post# 1021306 , Reply# 3   1/15/2019 at 21:10 by Stricklybojack (San Diego, CA)        

stricklybojack's profile picture
.
I donít know about belt drive machines but on the direct drive you can very easily remove the whole cabinet by tilting it forward. The only problem comes putting it back if your cabinet and/or frame is bent or damaged.
See video:







Post# 1021314 , Reply# 4   1/15/2019 at 22:09 by DADoES (TX,†U.S. of A.)        

dadoes's profile picture

The top deck does *not* lift up on DD machines, it's attached to the cabinet front/sides via screws from beneath.† The entire outer cabinet is removed with the top/lid attached as the video above shows, the rear panel is left standing attached to the base and holding the console.

The console anchor screws (if it has them instead of the clips) may be in a couple different locations depending on the design of it - at the back corners as the video shows, or at the front corners.† Some Kenmore models have them in front but under trim pieces that snap (carefully) off.





Forum Index:       Other Forums:                      



Comes to the Rescue!

The Discuss-o-Mat has stopped, buzzer is sounding!!!
If you would like to reply to this thread please log-in...

Discuss-O-MAT Log-In



New Members
Click Here To Sign Up.



                     


automaticwasher.org home
Discuss-o-Mat Forums
Vintage Brochures, Service and Owners Manuals
Fun Vintage Washer Ephemera
See It Wash!
Video Downloads
Audio Downloads
Picture of the Day
Patent of the Day
Photos of our Collections
The Old Aberdeen Farm
Vintage Service Manuals
Vintage washer/dryer/dishwasher to sell?
Technical/service questions?
Looking for Parts?
Website related questions?
Digital Millennium Copyright Act Policy
Our Privacy Policy