Thread Number: 79523  /  Tag: Modern Dryers
Duet gas dryer issue
[Down to Last]

Cool Washer Stuff on Amazon:
scroll >>> for more items
Post# 1034258   6/3/2019 at 00:09 by MattL (Flushing, MI)        

Got an odd issue with my Duet gas dryer.  Clothes have been taking a while to dry and did not seem all that warm coming out of the dryer.  Opened up the front panel and observed the burner.  When heat is called for it clicks, about 10 -15 seconds later another click and the igniter comes on. Gas vale opens and burns nice blue flame - for 20 seconds then cuts out.  Repeats over and over with a time out between cycles.  No vent blockage because it's not vented.

Post# 1034262 , Reply# 1   6/3/2019 at 01:20 by MattL (Flushing, MI)        
Chalk it up to operator error...

Being it's now June and cold weather is hopefully behind us  ( it is 45 degrees now...) I did 3 or 4 loads of bedding, blankets, sheets and coverlets.  i always clean the light filter when I start a dryer load, but rarely when I do several loads of laundry sequentially.  Turns out one of the blankets shed a lot of fiber and the lint filter was semi packed with lint.  Cleaned it and all is well.


Most of my stuff is years old and sheds very little lint anymore so it's rare to find more than a trace of lint on the screen, have to make a mental note to check between load with bedding.

Post# 1034263 , Reply# 2   6/3/2019 at 01:37 by Maytag85 (Sean A806)        

maytag85's profile picture
Sounds like you have issues with the gas valve coils. When the gas valve could go bad, the burner will randomly shut off, and it will work for the first heating cycle, but will shut off on the second heating cycle.

Post# 1034266 , Reply# 3   6/3/2019 at 05:14 by henene4 (Germany)        
Not vented

Remind me again - as we barely ever have contact with gas dryers over here - they do produce barely any CO, right, but tons of CO2 and still trace amounts of more problematic gasses like CO, NOx and such, especially if they burn not completly clean air, right?

Will it might be perfectly fine not to vent it, I would feel horribly uncomfortable.

Post# 1034269 , Reply# 4   6/3/2019 at 06:46 by Dustin92 (Jackson, MI)        

Gas dryers CAN produce carbon monoxide, but if it's working properly should produce only co2.. About the same as running a couple stovetop burners or maybe the oven. Does sound like possibly the gas valve coils or possibly the flame sensor getting flaky though. Both would be an easy repair that can be done from the front without pulling the dryer out.

Post# 1034275 , Reply# 5   6/3/2019 at 11:16 by combo52 (Beltsville,Md)        
Gas dryers Do produce some pollutants

combo52's profile picture

But are far cleaner than gas ranges because the flame is not in contact with any cooler metal surfaces like a pot of water on a stove top or the metal reflector of a broiler.



Post# 1034280 , Reply# 6   6/3/2019 at 12:35 by MattL (Flushing, MI)        

As I mentioned after cleaning the lint filter all is well. 


As to the CO2, not an issue.  I have both a smart co2/smoke detector and a CO2 alarm with a digital readout and it shows no carbon monoxide.  I'm sure the high output burner on my gas cooktop puts out more co2 than the dryer.  I'd gladly vent it, but it's placement makes it difficult.  Truth is I dry only a few loads a month.  All my dress shirts I put on hangers to dry as well as my jeans and most pants.  Towels and bedding do go into the dryer but I wait until I have a full load and as I live alone it can take some time to accumulate.

Forum Index:       Other Forums:                      

Comes to the Rescue!

The Discuss-o-Mat has stopped, buzzer is sounding!!!
If you would like to reply to this thread please log-in...

Discuss-O-MAT Log-In

New Members
Click Here To Sign Up.

Discuss-o-Mat Forums
Vintage Brochures, Service and Owners Manuals
Fun Vintage Washer Ephemera
See It Wash!
Video Downloads
Audio Downloads
Picture of the Day
Patent of the Day
Photos of our Collections
The Old Aberdeen Farm
Vintage Service Manuals
Vintage washer/dryer/dishwasher to sell?
Technical/service questions?
Looking for Parts?
Website related questions?
Digital Millennium Copyright Act Policy
Our Privacy Policy