|
Thread Number: 79601
/ Tag: Modern Automatic Washers
My Frigemore Is Acting Up |
[Down to Last] |  |
|
Post# 1035023 , Reply# 1 6/10/2019 at 18:59 (1,775 days old) by Yogitunes  (New Jersey) |
||
roaring during spin = bearing failure
easy enough just to replace the bearings and seals....I got the complete package off ebay for around 20.00.... this guy will give you some insight to replacing them.... I have done two so far....take your time through it, it will run smooth and quiet afterwards.... the one I did for Mark was super clean inside, everything came apart as if it was brand new....now it purrs like a kitten.....granted he only washes in hot or warm water, gain detergent, bleach when needed.... you should have attended the wash-in at Jerry's this past weekend....we could have had that thing rebuilt in no time... | ||
| Post# 1035051 , Reply# 3 6/10/2019 at 22:37 (1,775 days old) by IowaBear (Cedar Rapids, IA) | ||
 | ||
|
Post# 1035057 , Reply# 4 6/11/2019 at 02:09 (1,775 days old) by MattL (Flushing, MI) |
||
|
Yep, I've done bearings a few times, need to do one now. I discounted the kits on ebay, went for higher quality bearings, but it's not really the bearings that go bad it's the seal. So this time I"ll go for the cheaper version and hope to get another 8 years out of it. | ||
| Post# 1035060 , Reply# 5 6/11/2019 at 03:43 (1,775 days old) by washabear (Maryland) | ||
|
Thanks for the information and video. This is very helpful. | ||
| Forum Index: |
| Other Forums: |
|
|
|
|
|
Comes to the Rescue!
