|
Thread Number: 80248
/ Tag: Modern Automatic Washers
Flashing lights on Speed Queen FL after cycles completed? |
[Down to Last] |  |
Post# 1042010 8/17/2019 at 11:16 (2,047 days old) by Revvinkevin  (La-La Land) |
||
 A friend recently purchased a stacked Speed Queen front load washer & dryer. While it needed some cleaning, it works well, or seems to anyway. After running a cycle, once it’s complete, the “door“ light and the ”wash” light flash slowly and the washer will not start again until it’s been unplugged, then plug back in. One other thing, it doesn’t seem to drain very fast, but it does drain completely. One thing I noticed last night as it’s draining before spin, the tub rpm starts increasing while it’s still draining. I could hear there was still some water in the tub, but it was gone 2-3 seconds later. Any thoughts? Thanks in advance!
View Full Size
This post was last edited 08/17/2019 at 13:59 | ||
|
|
Post# 1042048 , Reply# 1 8/17/2019 at 17:23 (2,047 days old) by combo52 (50 Year Repair Tech Beltsville,Md) |
||
Gas SQ Stack | ||
| Post# 1042064 , Reply# 2 8/17/2019 at 18:59 (2,047 days old) by Stricklybojack (South Hams Devon UK) | ||
 | ||
| Post# 1042103 , Reply# 3 8/18/2019 at 12:03 (2,046 days old) by mrb627 (Buford, GA) | ||
Balance and Drain | ||
| Forum Index: |
| Other Forums: |
|
|
|
|
|
Comes to the Rescue!
